Rosewill RC216 User Manual download pdf (Page 9)

User Manual

SATA II / ATA 133 PCIe Card RC216

Rebuild Mirror Drive

When a failure to one member occurs, you will be notiﬁed by the RAID BIOS during boot. The

steps below will guide you in rebuilding a failed mirror set.

1. Replace he failed drive(s) with one of equal or greater capacity, then start the computer.

2. During boot press Ctrl+J to enter the RAID BIOS.

3. Select Rebuild Mirror Drive press Enter.

4. Please use arrow keys↑ and ↓ to select the array you want to rebuild, press Enter.

5. Please use arrow keys↑ and ↓ to select the destination disk, press Enter.

6. When rebuilding is ﬁnished, select Save And Exit Setup, press Enter.. When asked Save to

disk &Exit (Y/N)?, press Y to exit the BIOS.

BIOS Conﬁguration

The PCIe SATA II 300 + PATA Raid Card BIOS will appear every time your system starts up.

During this (POST) process, the BIOS will show up and indicate the devices attached to it.

Driver Installation

For Windows® 2000, XP and Server 2003 32bit

For New Installation

A new installation requires a ﬂoppy disk for the driver installation. To make this ﬂoppy disk, copy

the contents of the “RC-216\Floppy32” folder, found on the driver CD, onto a blank ﬂoppy disk

then follow the directions below.

1. Setup the RAID Array prior to Windows installation.

2. Follow Microsoft’s Windows installation procedure.

3. Restart the computer when prompted by Windows’ installation.

4. At the Windows Setup screen, press F6 to install the RAID driver.

5. When prompted, press S to specify the location of the driver.

6. Insert the ﬂoppy disk, then press Enter.

7. Select (Windows 2000) RAID Driver for JMicron JMB363 Controller or (Windows XP/2003)

RAID/AHCI Driver for JMicron JMB36X Controller, then press Enter.

8. Press Enter to ﬁnish driver installation, then follow the on-screen instructions to complete the

Windows installation.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Rosewill RC216 User Manual Page 9