Rosewill RC216 User Manual download pdf (Page 11)

User Manual

SATA II / ATA 133 PCIe Card RC216

For Windows® Vista 32 bit

For New Installation

A new installation requires a ﬂoppy disk for the driver installation. To make this ﬂoppy disk, copy

the contents of the “RC-216\Floppy32” folder, found on the driver CD, onto a blank ﬂoppy disk

then follow the directions below.

1. Setup the RAID Array prior to Windows installation.

2. Follow Microsoft’s Windows installation procedure.

3. Restart the computer when prompted by Windows’ installation.

4. At the Windows Setup screen, press Load Driver to install the driver.

5. Insert the ﬂoppy disk, please select JMicron JMB36X Controller (A:\jraid_f.inf), then press

Next. (Change A:\ to match your ﬂoppy drive letter)

6. Follow the on-screen instructions to complete the Windows installation.

For An Existing Installation

1. Setup the RAID Array prior to driver installation and boot up to Windows.

2. At the Found New Hardware Wizard window pop-up, please click Cancel button to cancel

the driver installation for the device at this moment. The driver for this device will be installed in

the next step.

3. Please insert the CD driver bound with PCIe SATA II 300 + PATA Raid Card into your CD-ROM

Drive.

4. At the Windows desktop, click Start, then Run.

5. Type D:\ RC-216\Setup.exe, click OK. (Change D:\ to match your CD-ROM drive letter)

6. Follow the on-screen instructions to complete the installation.

7. Restart Windows to complete the installation.

For Windows® Vista 64 bit