Rosewill RC-215 User Manual download pdf (Page 7)

SATA105G/ATA 133 RAID Controller Card RC215 User Manual

Rebuild Mirror Drive

When a failure to one member occurs, you will be notified by the RAID BIOS

during boot. The steps below will guide you in rebuilding a failed mirror set.

Replace he failed drive(s) with one of equal or greater capacity, then start the

computer.

Then you will see the following message shown by the PCI SATA+PATA RAID

card’s BIOS on the screen.

Power off and check the failed drive

Destory the Mirroring Relationship

Choose replacement drive and rebuild

Continue to boot

Select Choose replacement drive and rebuild, press Enter.

Select the replacement drive then press Enter.

When asked WARNING: Would you like to Continue? Press Y/N?, press Y to

accept.

The set will be rebuilt. The status of the rebuild is displayed in the menu.

When rebuild is completed, a Enter the VIA RAID Utility after exiting?(Y/N)

message will pop up inform you that rebuild is finished, press N to reboot

system.

RAID 0+1 (Mirroring+Striping)

This RAID array to be used on New/Blank hard drives, do not use existing

hard drive(s) with data. To create a RAID 0+1 set four hard drives are required.

Auto configuration (recommended)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Rosewill RC-215 User Manual Page 7