Rosewill RNX-N150PCe User Manual download pdf (Page 46)

2.4GHz Wireless Lite-N PCI-E Adapter RNX-N150PCe User Manual

Appendix C: FAQ

This chapter provides solutions to problems that may occur during the installation and

operation of the Wireless Adapter. Read the descriptions below to solve your problems.

1. I cannot communicate with the other computers linked via Ethernet

in the Infrastructure configuration.

1. Make sure that the PC to which the Adapter is associated is powered on.

2. Make sure that your Adapter is configured on the same channel and with the

same security options as with the other computers in the Infrastructure

configuration.

2. What should I do when the computer with the Adapter installed is

unable to connect to the wireless network and/or the Internet?

1. Check that the LED indicators for the broadband modem are indicating normal

activity. If not, there may be a problem with the broadband connection.

2. Check that the LED indicators on the wireless router are functioning properly. If

not, check that the AC power and Ethernet cables are firmly connected.

3. Check that the IP address, subnet mask, gateway, and DNS settings are correctly

entered for the network.

4. In Infrastructure mode, make sure the same Service Set Identifier (SSID) is

specified on the settings for the wireless clients and access points.

5. In Ad-Hoc mode, both wireless clients will need to have the same SSID. Please

note that it might be necessary to set up one client to establish a BSS (Basic

Service Set) and wait briefly before setting up other clients. This prevents several

clients from trying to establish a BSS at the same time, which can result in

multiple singular BSSs being established, rather than a single BSS with multiple

clients associated to it.

6. Check that the Network Connection for the wireless client is configured properly.

If Security is enabled, make sure that the correct encryption keys are entered on

both the Adapter and the access point.

3. I can’t find any wireless access point / wireless device in ‘Site

Survey’ function.

1. Click ‘Rescan’ for few more times and see if you can find any wireless access

point or wireless device.

2. Please move closer to any known wireless access point.

3. ‘Ad hoc’ function must be enabled for the wireless device you wish to establish a

direct wireless link.

4. Please adjust the position of network card (you may have to move your computer

if you’re using a notebook computer) and click ‘Rescan’ button for few more times.

1 2 ... 41 42 43 44 45 46 47

No comments

Rosewill RNX-N150PCe User Manual Page 46