Rosewill RC-226 User Manual download pdf (Page 3)

6Gbps SATA 2Ports Low Profile PCIe Gen2 Host Adapter User Manual

2. Put your Windows OS Setup CD into the CD-ROM/DVD drive, or diskette

including all Directories and Files under “SATA6G_M9128\Fresh” into the floppy

drive ‘A’ of XP system. Continue Step 3. if your system OS is XP, but jump to Step

5. for Windows 7/Vista.

3. Press ‘F6’ for third party SCSI or driver installation at the beginning of text mode

installation. Press 'S' when screen message asks and ‘Select’ & ‘Enter’

‘Marvell shared library for 32/64 bit (install first)’. Then Press 'S' when

screen message asks and repeat ‘Select’ & ‘Enter’ ‘Marvell 91XX SATA

Controller 32/64 bit Driver’.

4. Press 'Enter' again to continue on with text mode setup then go to Step 7. after

the XP installation is finished.

5. Follow the instructions to load file ‘mv91xx.inf’ by browsing either

“SATA6G_M9128\Fresh\amd64 or i386”. Then select your choices of disk

partition and other setup operations.

6. After setup examines your disks, it will copy files from OS CD to the hard drive

and restart the system. After restart the setup process will resume to finish the

Windows 7/Vista installation.

7. Once the Fresh Installation has completed, go to Section 2.3. to verify if the

correct installation.

2.2. Adding the HBA to an existing Windows 7 / Vista / XP installation

1. Power off the system. Insert SATA Card into an available PCIe slot. Power up the

system.

2. During system boot-up, Windows will display the messages such as 'Found

New Hardware Wizard' (XP), ‘Windows needs to install...’ (Vista), &

‘Device driver software was not successfully installed’ (Windows 7).

3. ‘Cancel’ and go to auto driver installation by browsing the Driver CD.

4. Run the installer ‘drvSetup.exe’ on Driver CD “E:\SATA6G_M9128” to have

the latest driver for 32bit /64bit Windows until ‘Finish’.

5. Windows will display message again to ask you continue the installation.

6. ‘Cancel’ and go to auto driver installation by browsing the Driver CD.

7. Run installer ‘consoleSetup.exe’ on Driver CD “E:\SATA6G_M9128 \Config”

until ‘Finish’.

8. Once the Adding Installation has completed, go to Section 2.3. to verify if the

correct installation.

2.3. Verifying The installation Windows 7 / Vista /XP

1 2 3 4

No comments

Rosewill RC-226 User Manual Page 3