Rosewill RC-209-EX User Manual download pdf (Page 7)

User Manual

e-SATA 4 Port PCI Adaptor with RAID RC-209-EX

Mode 4 - ABCE Active

Note: There are six SATA ports in Serial ATA 4-Channel RAID adapter. We named these ports

character A through F. Ports A to D are internal SATA ports and E & F are external SATA ports. By

changing the jumper setting on the Serial ATA 4-Channel RAID adapter that allows you to select

between external and internal ports to use. By default, Port A, B, C and D are working.

Hardware Installation

1. Turn Off the power to your computer and any other connected peripheral devices.

2. Unplug the power cord form the back of the computer.

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. To install the card, carefully align the card’s bus connector with the selected PCI slot on the

motherboard. Push the board down ﬁrmly, but gently, until it is well seated.

6. Replace the slot bracket’s holding screw to secure the card.

Device Connection

The Serial ATA 4-Channel RAID adapter is a four channel Serial ATA controller that supports up

to four Serial ATA hard disk drives. It is recommended to use identical hard drives for all RAID

conﬁgurations.

1. Install your hard disk drive(s) in chassis.

2. Connect the Serial ATA hard disk drive to the system power supply using the included Serial

ATA power cable.

3. Connect one end of the Serial ATA cable to the hard disk drive.

4. Attach the other end of the Serial ATA cable to the Serial ATA controller on the Serial ATA

4-Channel RAID adapter.

5. Follow the same instructions to connect up to four hard drives. Device connection is now

complete.

6. Replace the computer cover and reconnect the power cord.

E F

1 & 2 PIN close

2 & 3 PIN close

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Rosewill RC-209-EX User Manual Page 7